News

In the stranding machine, there may be defects such as single wire grooving or surface pockmarking, scar, triangular crack, slag inclusion, etc. In this case, we don't have to worry too much. Find out the reason and then solve it.

Strander in the process of use, stranding products are generally supplied in a coil. For large cross-section stranded wires, we need to arrange them one by one, especially the bottom wires.

During the use of extruder, if there is screw leakage, how should we deal with it? In this case, we should first think about the causes of leakage, and then targeted solutions.

All kinds of problems may appear when stranding the core by strander. Loose strand is one of the most common. When it comes to loose stocks, we should not panic. Find out the reason, and then solve it.

In the course of using the strander, there may be single strand back and loose strand in the bundle. How should we deal with this situation?

Various problems may appear in the process of stranding machine. Scratch on the surface of stranded wire is one of them. So in the face of such a situation, how should we deal with it?

Cable extruder can be used in many fields, such as extrusion machine for agriculture, electric appliance, cable, machinery, etc. So what should we pay attention to when we operate the cable extruder?

Strander is mainly composed of stranding cage, traction device, take-up device and electrical control. It is mainly suitable for stranding wire and cable conductor core. The strander shall operate according to the following steps when stranding the core: